Neon L4-2.0L VIN C (1997)
1.
Locate the radiator fan relay on the left front inner frame rail just behind the radiator (Figure 3).
2.
Disconnect the radiator fan relay wiring connector.
3.
Remove and discard the radiator fan relay.
4.
Install the new radiator fan relay. Tighten the fasteners to 45 in-lbs (5 N.m).
CAUTION:
Do not over torque screws. To ensure heat transfer and proper operation, the new radiator fan relay must be installed using both of the screws.
5.
Connect the radiator fan relay electrical connector. Slide the red latch to the locked position.
6.
Lower the vehicle.
7.
Connect the negative battery cable.
C. Install the Authorized Label
1.
Type or print (with a ball point pen) the following information (Figure 4) on the Authorized Modifications label (PN 4275086).
2.
Peel the label from its backing and apply it near the Vehicle Emission Control Information Label located in the engine compartment.
D. Complete Proof of Correction Form
1.
Complete a Vehicle emission Recall Proof of Correction Form and supply it to the vehicle owner.
Dealer Service Instructions
IMPORTANT
DEALER SERVICE INSTRUCTIONS
Emissions Recalls # 7691 and # 7692-- Radiator Fan Relay
^
This service requirement applies only to 1997 and 1998 model year Dodge and Plymouth Neon (PL) vehicles built at the Toluca Assembly Plant
("T" in the 11th VIN Position) through September 10, 1997 (MDH 0910XX) and:
^
Currently Located Out of California -- Recall # 7691
^
Currently Located In California -- Recall # 7692
^
The radiator fan relay on the above listed vehicles, may not turn on the radiator cooling fans. To correct this condition, the radiator fan relay must be
replaced and a jumper wire that contains a diode must be installed.
^
Effective immediately all repairs on involved vehicles are to be performed according to this recall notification. The Labor Operation Number for
TSB 07-07-97 and 07-04-98 is being canceled.
