Neon L4-2.0L VIN C (1997)
7. Lift module up until the wire connector is visible and disconnect the 4-way wire connector from module. Unlock the red locking tab and
compress lock to release the connector.
INSTALLATION
-
For installation, reverse the above procedures. Ensure that the red locking tab is in the lock position after installing the connector. Tighten trim
screws to 2 N.m (20 in. lbs.) torque. Tighten the module nuts to 22 to 34 N.m (200 to 300 in. lbs.) torque. Do not connect battery negative
cable. Refer to Diagnosis and Testing for Airbag System Test procedures.
Deployed Module
REMOVAL
When removing a deployed module, rubber gloves, eye protection, and a long-sleeved shirt should be worn, as there may be deposits on the
surface which could irritate the skin and eyes.
1. Disconnect and isolate the battery negative cable.
2. Roll/fold airbag towards instrument panel.
3. Close door over folded airbag and tape door closed.
4. Remove instrument panel top cover.
5. Remove instrument panel right trim panel.
6. Open glove box and push the sides inward allowing the door bumper to pass and box to open.
7. Remove the four trim screws which attach the module to the top instrument panel.
8. Remove two module attaching nuts from the support structure.
9. Lift module up until the wire connector is visible and disconnect the 4-way wire connector from module. Unlock the red locking tab and
compress lock to release the connector.
INSTALLATION
-
For installation, reverse the above procedures. Ensure that the red locking tab is in the lock position after installing the connector. Tighten trim
screws to 2 N.m (20 in lbs.) torque. Tighten the module nuts to 22 to 34 N.m (200 to 300 in lbs.) torque. Do not connect battery negative
cable. Refer to Diagnosis and Testing for Airbag System Test procedures.
