Neon L4-2.0L VIN C (1997)
17.
Install the transmission shift lever handle.
18.
Connect the DRB III, turn the ignition switch to the ON position and then exit the vehicle with the DRB III.
19.
Reconnect the negative battery cable and then watch the airbag light in the instrument cluster, it should light for about 6-8 seconds and then go out.
20.
With the DRB III, verify that no system diagnostic codes have been set.
NOTE:
If the airbag warning lamp fails to light or the light stays on, or the DRB displays a diagnostic code, a system malfunction exists. Diagnose and repair
the condition following normal service procedures.
Service Procedure For Viper GTS Coupe (SR) Vehicles:
1.
Remove the left rear wheel and tire assembly.
2.
Remove the left rear wheel well inner splash shield.
3.
With the ignition key in the OFF position, disconnect and isolate the negative battery cable. WAIT TWO (2) MINUTES FOR THE SYSTEM
CAPACITOR TO DISCHARGE BEFORE CONTINUING.
Note:
To enhance customer satisfaction, remember to record all radio settings before disconnecting the battery and to reset all electronic memory (clock,
radio settings, etc.) when you have completed the service procedure.
4.
Remove the instrument panel center bezel and then disconnect the rear window defogger switch, the power window switches and the lighter
(Figure 15).
