Neon L4-2.0L VIN C (1997)
5.
Remove the right and left knee blockers (Figure 16).
6.
Remove the headlamp switch knob by inserting a paper clip in the hole under the knob and pushing gently to release the lock clip (Figure 16).
7.
Remove the tilt steering handle.
8.
Remove the upper steering column shroud.
9.
Remove the instrument panel bezel (Figure 16).
NOTE:
Be careful not to break the headlamp switch lock tab when removing the I/P bezel.
10.
Remove the two (2) radio mounting screws.
11.
Remove the radio and disconnect the wire connector, coaxial cable and antenna cable.
12.
Remove the radio from the vehicle.
13.
Remove the HVAC control module. Only disconnect the vacuum and electrical connectors. Do not disconnect the cable. Set the control module
aside.
