Neon L4-2.0L VIN C (1997)
Fig. 24 Removing Wires From Connector
4. Push level sensor signal and ground terminals out of the connector.
Fig. 25 Loosening Level Sensor
5. Insert a screwdriver between the fuel pump module and the top of the level sensor housing.
Fig. 26 Level Sensor Removal/Installation
6. Push level sensor down slightly.
-
Ensure tab at bottom of sensor locks in place.
7. Install level sensor wires in connector. Push the wires up through the connector and then pull them down until they lock in place. Ensure signal and
ground wires are installed in the correct position.
8. Install locking wedge on connector.
9. Push connector up into bottom of fuel pump module electrical connector.
10. Install fuel pump module.