Neon L4-2.0L VIN C (1997)
Manifold Pressure/Vacuum Sensor: Service and Repair
MAP/IAT Sensor
NOTE: The MAP/IAT sensor attaches to the intake manifold plenum.
REMOVAL
1. Disconnect the electrical connector from the MAP/IAT sensor.
2. Remove sensor mounting screws.
3. Remove sensor
INSTALLATION
1. Insert sensor into intake manifold while making sure not to damage 0-ring seal.
2. Tighten mounting screws to 2 Nm (20 in lb) torque for plastic manifold and 3 Nm (30 in lb) for aluminum manifold.
3. Attach electrical connector to sensor.
