Neon L4-2.0L VIN C (1997)
Control Arm Bushing: Service and Repair
Lower Control Arm Front Isolator Bushing
NOTE: To perform the removal and replacement of the lower control arm front isolator bushing, the lower control arm must be removed from the
vehicle.
REMOVAL
1. Remove the lower control arm assembly from the vehicle.
2. Mount Remover/Installer, Special Tool C-4212-F, or equivalent in a vise. Install Bushing Remover, Special Tool 6804 and Bushing Receiver,
Special Tool 6758 on Special Tool C-4212-F, or equivalents.
3. Install lower control arm on Special Tools assembled for removal of the front isolator bushing as shown. Be sure Special Tool 6758 is square on
lower control arm and Special Tool 6804 is positioned correctly on isolator bushing.
4. Tighten screw on Remover/Installer Special Tool C-4212-F, or equivalent to press front bushing out of lower control arm.
INSTALLATION
1. Mount Installer Cup, Special Tool C-4212-F on Remover/Installer, Special Tool C-4212-F, or equivalents. Then mount Bushing Installer; Special
Tool 6810 on screw portion of Remover/Installer Special Tool C-4212-F, or equivalent.
