PB 150 V8-318 5.2L VIN T 2-BBL (1983)
Axle Shaft: Service and Repair
Axle Shafts & Bearings Replace
Fig. 4 Removing differential pinion shaft lock pin
Fig. 5 Removing C-lock washers
Fig. 6 Removing axle shaft bearing and seal. Exc. 9-1/4 inch HD axle
Fig. 7 Removing axle shaft & bearing seal. 1984-87 9-1/4 inch HD axle
8-3/8 & 9-1/4 INCH
1. Raise and support vehicle and remove brake drum.
2. Clean area around housing cover, then loosen housing cover and allow lubricant to drain. Remove cover.
3. Turn differential case until pinion shaft lock screw is accessible and remove lock screw and pinion shaft.
4. Push axle shaft inward and remove C-washer locks from axle shaft, then pull axle shaft from housing being careful not to damage axle