PB 350 V8-360 5.9L VIN T 4-bbl (1982)
Electric Assist Choke: Testing and Inspection
1973
1. Disconnect electrical heating element from control switch.
2. Connect an ohmmeter between the crimped junction of this wire at the choke end, and ground.
NOTE: Do not connect to the steel heater casing.
3. Electrical resistance of 4-6 ohms is normal. If ohmmeter reading indicates an open or short, replace choke assembly.
1974-82
1. Disconnect B+ wire from control switch.
2. Connect an ohmmeter between an exposed portion of the choke wire connector at the switch (not the B+ terminal), and ground.
3. Electrical resistance of 4-12 ohms is normal. If ohmmeter reading indicates an open or short, replace choke assembly.
