PB 350 V8-360 5.9L VIN T 4-bbl (1982)
Choke Temperature Control Switch: Testing and Inspection
1. Check test light by connecting its battery and carefully noting intensity of light.
2. Before starting engine, disconnect both electrical connectors from the control switch on 1973 vehicles, "BAT" connector from the control switch
on 1974-76 vehicles, and ignition harness electrical connector from control switch on 1977-82 vehicles.
3. Connect test light to the load (small or choke) terminal of the control switch and to ground.
4. Start engine and allow it to reach normal operating temperature.
5. Apply 12 volts to the "BAT" terminal of control switch on 1973-76 vehicles, or to ignition harness terminal of control switch on 1977-82 vehicles.
6. If test light does not have the same intensity as that noted in step 1, the control switch is defective and must be replaced.
NOTE: On 1973-76 vehicles, if test light remains lit for more than 5 minutes, the control switch is defective and must be replaced.
