Prowler V6-3.5L VIN G (1999)
Vacuum Seal Installed On Master Cylinder
1. Install a NEW vacuum seal on the master cylinder. Make sure the seal sits squarely in the groove on the master cylinder.
Note: It is not necessary to bleed the entire hydraulic system after replacing the master cylinder, providing that the master cylinder has been filled
and bled prior to installation, and the vehicle's brake lines have not been open to the air for an extended period of time.
2. Bleed the master cylinder assembly prior to mounting it on the power brake booster. Refer to Bleeding Master Cylinder for the proper procedure.
3. Position the master cylinder on the studs of the vacuum booster. Be sure the push rod on the vacuum booster is correctly aligned with the piston of
the master cylinder.
4. Push the master cylinder up against the front of the vacuum booster.
5. Install the master cylinder to vacuum booster mounting nuts and tighten to a torque of 28 Nm (250 inch lbs.).
6. Connect brake tubes to master cylinder primary and secondary ports. Tighten fittings to a torque of 17 Nm (145 inch lbs.).
