Prowler V6-3.5L VIN G (1999)
Parking Brake Cable: Service and Repair
On this vehicle, Never attempt to repair the park brake output cable in any manner.
This vehicle has only 2 serviceable park brake cables. Each cable leads from the park brake lever output cable equalizer to either the left or right rear
wheel park brake assembly. The park brake lever output cable is not replaceable as a separate component. It is replaced as part of the park brake lever.
Note: Remove only one rear park brake cable from rear brakes at a time. Failure to do so will result in high efforts required to connect park brake cables
to equalizer or park brake lever at rear wheel brakes.
For replacement of the rear park brake cables follow the procedure as listed below.
Remove
Shift Knob Attachment
1. Remove shift knob from shifter Shift knob is attached to shifter using an hex head set screw. Access to set screw is from the front side of the shift
knob.
Shift Bezel Wiring Harness
2. Remove shift bezel from center console. Shift bezel is removed by carefully pulling upward along the edge until the retaining clips unlatch from
the center console.
3. Disconnect shift bezel wiring harness from vehicle wiring harness.