Prowler V6-3.5L VIN G (1999)
5. Connect wiring harness electrical connector on brake warning light ground switch on park brake mechanism.
6. Cycle park brake lever once to position park brake cables. Then return the park brake lever its released position. Check the rear wheels of the
vehicle. They should rotate freely without dragging.
7. Raise park brake lever to its fully engaged position. This is necessary to allow installation of the center console.
8. Install center console.
9. Install the 4 screws, mounting console, storage tray and lid.
10. Install screw mounting front of center console to console bracket.
11. Connect shift bezel wiring harness to vehicle wiring harness.
12. Install shift bezel on center console. Shift bezel is installed by firmly pressing it down on center console until the 4 retaining clips are holding it to
the center console.
13. Install shift knob on shifter. Install and securely tighten set screw holding shift knob to shifter. Access to set screw is from the front side of the shift
knob.
