Prowler V6-3.5L VIN G (1999)
Camshaft: Service and Repair
Removal and Installation
Removal
Camshafts are serviced from the rear of the cylinder head. The cylinder head must be removed.
1. Remove Camshaft Sprocket. Refer to Camshaft Gear/Sprocket, Service and Repair, Removal and Installation with Timing Procedure.
2. Remove cylinder head.
3. Mark the rocker arm and shaft assembly before removal. Remove the rocker arm and shaft assembly from the head.
4. Remove the rear camshaft cover and O-ring from head.
CAUTION: Be careful not to nick or scratch the journals when removing the camshaft.
5. Carefully remove the camshaft from the rear of the cylinder head.
Installation
1. Lubricate camshaft journals and cam with clean engine oil and install camshaft into cylinder head.
2. Install the rocker arm assembly.
NOTE: Refer to Camshaft Gear/Sprocket, Removal and Installation with Timing Procedure to complete camshaft installation.