Prowler V6-3.5L VIN G (1999)
Crankshaft: Service and Repair
Removal and Installation
Removal
1. Remove engine from vehicle.
2. Remove oil pan.
3. Remove oil pick-up tube.
4. Remove idler pulley for accessory drive belt.
5. Remove front lower timing belt cover.
6. Remove front main timing belt cover.
7. Remove front left side timing belt cover.
8. Remove crankshaft damper.
9. Remove timing belt tensioner and timing belt.
10. Remove crankshaft sprocket.
11. Tap dowel pin out of crankshaft.
12. Remove oil pump assembly
13. Remove rear crankshaft oil seal retainer.
Connecting Rod To Cylinder Identification
14. Remove connecting rod bearing caps. Connecting rod bearing caps are not interchangeable and should be marked before removal to insure correct
assembly.
Main Bearing Cap Identification
15. Remove main bearing caps. Main bearing caps are not interchangeable and are marked to insure correct assembly.
16. Remove Crankshaft.
NOTE: Before installing Crankshaft refer to Crankshaft Main Bearing, Fitting Main Bearings and Connecting Rod Bearing, Service and Repair,
Installation.
Installation