Prowler V6-3.5L VIN G (1999)
Air Door Cable: Service and Repair
Fig 42 Temperature Cable A/C Housing
The blend-air (temperature) door is actuated by a cable which mechanically positions the temperature door.
The temperature door actuator is located at the center of the A/C Heater housing at the center tunnel.
REMOVAL
1. Place the ignition key in the OFF position before removing control module.
2. Remove instrument panel.
3. Release the temperature control cable retaining clip from the top of the control module. Retain the clip for future use. Then disconnect the
temperature control cable.
4. Disconnect cable at housing.
5. Remove cable core end from temperature actuator lever.
INSTALLATION
For installation, reverse the above procedures.