Prowler V6-3.5L VIN G (1999)
Wheel Fastener: Service and Repair
Front
CAUTION: If a wheel mounting stud needs to be replaced in the hub/bearing, the studs CAN NOT be hammered out of the hub flange. If a stud is
removed by hammering it out of the bearing flange, damage to the hub bearing will occur leading to premature bearing failure.
NOTES:
-
The following procedure and special tools shown MUST be used when replacing wheel attaching studs.
-
The hub and bearing assembly does not require removal from the steering knuckle to replace wheel attaching studs in the hub and bearing
assembly.
REMOVE
1. Raise vehicle on jackstands or centered on a frame contact type hoist.
NOTE: When removing the center cap from the wheel do not use a sharp or hard tool. Use of such a tool can mare the finish on the wheel and
damage the center cap.
2. Remove the center cap from the wheel. Center cap is removed by inset tiny a trim stick into the notch on the center cap and prying it off the wheel.
3. Remove front wheel and tire.
4. Remove the 2 bolts attaching the brake caliper to the caliper adapter.
