Prowler V6-3.5L VIN G (1999)
INSTALL
1. Install replacement wheel stud into flange of hub/bearing. Install washers on wheel stud, then install a wheel lug nut on stud with flat side of lug
nut against washers.
2. Tighten the wheel lug nut, pulling the wheel stud into the flange of the hub/bearing. When the head of the stud is fully seated against the bearing
flange, remove lug nut and washers from wheel stud.
3. Install the rotor on the hub/bearing.
4. Install the brake caliper on the caliper adapter.
5. Install the brake caliper attaching bolts and tighten to a torque of 41 Nm (30 ft. lbs.).
6. Install the wheel and tire.
7. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 122 Nm (90 ft. lbs.).
8. Install the center cap on the wheel
9. Lower the vehicle.