Prowler V6-3.5L VIN G (1999)
Fuel Pump Relay: Testing and Inspection
AUTOMATIC SHUTDOWN (ASD) AND FUEL PUMP RELAYS
ASD And Fuel Pump Relay Terminals
ASD And Fuel Pump Relay Terminals
The following description of operation and tests apply only to the Automatic Shutdown (ASD) and fuel pump relays. The terminals on the bottom
of each relay are numbered.
Operation
-
Terminal number 30 is connected to battery voltage. For both the ASD and fuel pump relays, terminal 30 is connected to battery voltage at all
times.
-
The PCM grounds the coil side of the relay through terminal number 85.
-
Terminal number 86 supplies voltage to the coil side of the relay.
-
When the PCM de-energizes the ASD and fuel pump relays, terminal number 87A connects to terminal 30. This is the Off position. In the off
position, voltage is not supplied to the rest of the circuit. Terminal 87A is the center terminal on the relay.
-
When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30. This is the On position. Terminal 87 supplies
voltage to the rest of the circuit.
Testing
The following procedure applies to the ASD and fuel pump relays.
1. Remove relay from connector before testing.
2. With the relay removed from the vehicle, use an ohmmeter to check the resistance between terminals 85 and 86. The resistance should be between
75 ± 5 ohms.
3. Connect the ohmmeter between terminals 30 and 87A. The ohmmeter should show continuity between terminals 30 and 87A.
4. Connect the ohmmeter between terminals 87 and 30. The ohmmeter should not show continuity at this time.
5. Connect one end of a jumper wire (16 gauge or smaller) to relay terminal 85. Connect the other end of the jumper wire to the ground side of a 12
volt power source.
6. Connect one end of another jumper wire (16 gauge or smaller) to the power side of the 12 volt power source. Do not attach the other end of the
jumper wire to the relay at this time.
