Prowler V6-3.5L VIN G (1999)
Technical Service Bulletin # 14-02-99
Date: 990618
Engine - Hissing Noise When Idling
NUMBER: 14-02-99
GROUP: Fuel
DATE: June 18, 1999
SUBJECT:
"Hiss" Noise From Engine When Idling
OVERVIEW:
This bulletin involves replacing the throttle body assembly.
MODELS:
1998 - 1999
(LH)
Concorde/Intrepid/LHS/300M
1999
(PR)
Prowler
NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 3.2L OR 3.5L ENGINE.
SYMPTOM/CONDITION:
"Hiss" noise similar to a vacuum leak during engine idle and/or low RPM driving conditions. The noise is most noticeable during cold engine operation
from outside the vehicle, but may also be heard at normal operating temperatures and/or from inside the vehicle.
DIAGNOSIS:
Using the Mopar Diagnostic System (MDS/MDS2) and or the Diagnostic Scan Tool (DRB III(R)) with the appropriate Diagnostic Procedures Manual,
verify all engine/transmission systems are functioning as designed. If Diagnostic Trouble Codes (DTC's) are present, record them on the repair order and
repair as necessary before proceeding further with this bulletin. If no DTC's are present, check all engine vacuum lines, connections, and air induction
tubes including the air cleaner and air cleaner filter box to assure that no restrictions, vacuum or air leaks exist. Verify that the EGR tube and seals are
properly seated. Check throttle body gasket seating and for cracks/splits or missing material. If no problems are found and the noise is still present,
perform the Repair Procedure.
PARTS REQUIRED:
1
04591168AC
Throttle Body, LH Vehicles
1
04865278AB
Throttle Body, PR Vehicles
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
14-30-01-90
LH/LHS/300M
0.8 Hrs.
14-30-01-90
PR
0.4 Hrs.
FAILURE CODE: P8 - New Part
Repair Procedure
THIS REPAIR IS COMPATIBLE WITH DAIMLERCHRYSLER'S MOBILE SERVICE PROGRAM AND DOES NOT REQUIRE HOISTS OR
OTHER FULL SERVICE FACILITY SPECIAL EQUIPMENT.
1.
Disconnect and isolate the negative battery cable remote terminal.
2.
Remove wiper arms (LH only).
3.
Remove cowl screen (LH only).
4.
Remove cowl plenum (LH only).
5.
Disconnect air plenum from throttle body.
6.
Remove throttle cable bracket.