Prowler V6-35L VIN G - Throttle Cable/Linkage Service & Repair (1999)
Throttle Cable/Linkage: Service and Repair
CAUTION: When servicing the accelerator pedal, throttle cable or speed control cable, do not damage or kink the core wire inside the cable sheathing.
REMOVAL
Throttle Cable Removal/Installation
1. Working from the engine compartment, hold the throttle body throttle lever in the wide open position. Pull the cable forward and slide it out of the
throttle body cam.
2. From inside the vehicle, hold up the pedal and remove the cable retainer and throttle cable from the upper end of the pedal shaft.
3. Remove retainer clip from throttle cable and grommet at dash panel.
4. From the engine compartment, pull the throttle cable out of the dash panel grommet. The grommet should remain in the dash panel.
5. Remove the throttle cable from throttle bracket by carefully compressing both retaining ears simultaneously. Then gently pull the throttle cable
from throttle bracket.
INSTALLATION
1. From the engine compartment, push the housing end fitting into the dash panel grommet.
2. Install the cable housing (throttle body end) into the cable mounting bracket on the engine.
3. From inside the vehicle, hold up the pedal and install throttle cable and cable retainer in the upper end of the pedal shaft.
4. At the dash panel, install the cable retainer clip between the end of the throttle cable fitting and grommet.
5. From the engine compartment, rotate the throttle lever to wide open and install the throttle cable.
