Prowler V6-3.5L VIN G (1999)
Ignition Coil: Service and Repair
REMOVAL
1. Prior to removing the ignition coils, spray compressed air around the coil area and spark plug.
2. Remove electrical connector from ignition coil.
On 3.5L engines, it is necessary to loosen the screws by alternating back and forth. Do not lose the spacers under the coil when loosening the
screws.
3. Remove 2 fasteners from ignition coil.
4. Remove ignition coil.
INSTALLATION
1. Install ignition coil onto boot for spark plug.
2. Install coil screws and tighten to 6.7 Nm (60 in. lbs.).
3. Connect the electrical connector.