Prowler V6-3.5L VIN G (1999)
^
Follow DRBIII(R) prompts carefully.
^
Power down the DRBIII(R) then cycle ignition before powering up the DRBIII(R) to attempt the flash.
CUMMINS
Types:
^
CM551 and CM84x series
NOTE:
Cummins flash reprogrammable PCMs are used on 1998.5 and newer Dodge Trucks.
Abort Recovery Specifics:
^
Follow DRBIII(R) prompts carefully. Model Year 2000 and earlier vehicles have one Engine Control Fuse to pull when prompted by the DRBIII(R).
Model Year 2001 and later have two Engine Control Fuses (one 20 Amp and one 30 Amp) to pull when prompted by the DRBIII(R). The fuse(s) are
located in the PDC and need to be pulled/removed, when prompted, for at least 10 seconds.
SIEMENS
Types:
^
SIM-70
NOTE:
The SIM-70 is currently used on BUX PL and PG vehicles with a 1.6L ONLY. Abort Recovery Specifics:
Follow DRBIII(R) prompts carefully.
BOSCH
Types:
^
EDC15V, EDC15-C5, and EDC16
NOTE:
While there have been other Bosch modules, the EDC15V is not flash reprogrammable.
Transmission controllers are usually flashed on the vehicle (since 1996).
Technicians may set the pinion factor on "NEW" modules either before or after flash reprogramming. Suggestions follow.
After flash reprogramming and before returning the vehicle to the customer, always perform a "QuickLearn" to the TCM.
EATX
Types:
^
EATX, EATX 2, EATX 3, EATX 3A, EATX 3B, EATX 4, and EATX 4A
NOTE:
Table shows which TCM was installed "as-built". Often TCMs are superseded by parts and or a service bulletin.
Abort Recovery Specifics:
^
1999 - 2000 WJ and 2000 AN/DN using 4.7L engines the service replacement EATX4A part numbers 56041814AD and 56028227AH currently
display a P/N read failed error after the flash is completed during PIN verification. This DOES NOT mean the flash failed. Check for the part number
using DRBIII(R) in standalone mode. This exists only for the service replacement modules listed above. Flash reprogramming for OE modules flash
and read the part number correctly. Follow DRBIII(R) prompts carefully.
NGC
Types:
