Prowler V6-3.5L VIN G (1999)
Socket In Lock Cylinder Housing
2. The shaft at the end of the lock cylinder aligns with the socket in the end of the housing. To align the socket with the lock cylinder, ensure the
socket is in the RUN position.
Lock Cylinder Installtion
3. Align the lock cylinder with the grooves in the housing. Slide the lock cylinder into the housing until the tab sticks through the opening in the
housing.
4. Turn key to OFF position. Remove key.
5. If the vehicle has column shift and a new lock cylinder was used, install and adjust a new interlock cassette. Refer to Ignition Interlock. If the
vehicle has a floor shift, adjust the interlock cable when the lock cylinder is replaced. Refer to the Floor Shift Interlock Adjustment procedure.
6. Install upper and lower cover on steering column.
7. Install tilt lever.
8. Connect negative cable to battery.