Prowler V6-3.5L VIN G (1999)
Checking Rear Curb Height Measurement
NOTE: The bar being used to measure the vehicle curb height must be sitting on the same surface as the rear tires such as the rear skid plates on the
alignment rack. If the bar is not placed on the same surface as the tires it will affect the accuracy of the curb height measurement. Also, the bar must be
stiff enough so it will not bend when spanning the alignment rack.
1. Place the metal bar across the alignment rack. The metal bar must to be placed on the same surface of the alignment rack as the tires are sitting on
such as the skid plates for the rear tires.
2. Using a ruler measure the rear curb height of the vehicle. The curb height measurement is taken from the bottom surface of the frame rail to the
bottom edge of the metal bar. The curb height measurement must be taken next to the Principal Locating Point (PLP) hole on both the left and right
side of the vehicle.
