Prowler V6-3.5L VIN G (1999)
Steering Gear: Service and Repair
Removal
NOTE: The power steering gear can NOT be repaired or adjusted. If a malfunction or oil leak occurs. The complete steering gear must be replaced.
1. Position the key cylinder in the lock position.
2. Rotate steering wheel 1/2 turn to the left to engage the steering column lock.
3. Disconnect the negative (-) cable from the battery and isolate cable.
4. Using a siphon pump, remove as much power steering fluid as possible from the power steering fluid reservoir.
5. Raise vehicle on jackstands or centered on a hoist.
NOTE: When removing the center cap from the wheel do not use a sharp or hard tool. Use of such a tool can mare the finish on the wheel and
damage the center cap.
6. Remove the center cap from the wheel. Center cap is removed by inserting a trim stick into the notch on the center cap and prying it off the wheel.
7. Remove wheels and tires from vehicle.
8. Remove the 3 nuts mounting the front fender brackets to the steering knuckles. Remove both front fenders from the steering knuckles.