Prowler V6-3.5L VIN G (1999)
Steering Gear: Testing and Inspection
GENERAL INFORMATION
The following procedure is to be used to test the operation of the power steering system on this vehicle. This test will provide the flow rate of the
power steering pump along with the maximum relief pressure. This test is to be performed any time a power steering system problem is present to
determine if the power steering pump or power steering gear is not functioning properly. The following pressure and flow test is performed using
Pressure/Flow Tester, Special Tool 6815, or equivalent.
CAUTION: To prevent personal injury, safety goggles should be worn at all times when performing any test procedures or work on the power steering
pump or power steering gear.
TEST PROCEDURE
1. Install Pressure Hose, Special Tool 6959 in the inlet fitting on Pressure/Flow Tester, Special Tool 6815. Install Pressure Hose, Special Tool 6905
in the outlet fitting on Pressure/Flow Tester, Special Tool 6815. Install Pressure Hose, Special Tool 6713-1, or equivalent on Pressure Hose,
Special Tool 6905, or equivalent. Install Adapter Fitting, Special Tool 8185-2, or equivalent on Pressure Hose, Special Tool 6959, or equivalent.
2. Remove power steering fluid pressure hose from steering gear.