Prowler V6-3.5L VIN G (1999)
5. Grasp the arms of the stabilizer bar and pull downward until the attaching link mounting nuts are accessible.
6. Remove the stabilizer bar attaching link nut using the following procedure. Keep the attaching link stud from rotating using a Torx Plus 40 IP Bit
placed in the end of the stud. Using a wrench remove the nut from the attaching link stud.
7. Remove the attaching link from the stabilizer bar
INSTALL
1. Install new stabilizer bar attaching link so the attaching link stud is facing outward on the stabilizer bar. Install the nut on the attaching link stud.
Use the same procedure as when removing the nut to keep the stud from rotating.
2. Hold the attaching link stud from rotating using a Torx Plus 40 IP Bit placed in the end of the stud. Using a crowfoot as shown tighten the
stabilizer bar attaching link nut to a torque of 122 Nm (90 ft. lbs.).
3. Push upward on the arms of the stabilizer bar to position the stabilizer bar attaching links as close as possible to the mounting holes in the rocket
arms.
4. Lower the vehicle until the front tires are supporting the weight of the vehicle.
NOTE: When installing the stabilizer bar attaching link to rocker arm bolts it may be necessary to raise or lower the vehicle slightly. This will
help align the bolts with the holes in the rocker arms making it easier to install the bolts in the rocker arms.
