Prowler V6-3.5L VIN G (1999)
Fig. 63
3. Index the inner differential adjuster with a cross hair as shown in (Fig. 63).
CAUTION: If short stub shaft has corrosion, use caution when removing differential cover. Inspect seal and shaft for damage after removal of
cover. Replace shaft and/or seal as required.
Fig. 64
4. Index outer adjuster (Fig. 64). Remove lock bracket and back out adjuster exactly one revolution. Then remove differential cover.
5. Remove The inner adjuster lock bracket. Then remove the inner adjuster.
CAUTION: Keep the inner adjuster for reinstallation.
6. Lube inner adjuster threads with gear oil and reinstall to the cross haired index marks.
7. Install the differential carrier. Then install stub shaft seal protector.
8. Install the differential cover/outer adjuster assembly with sealant applied. Install and tighten differential cover bolts.
9. Tighten the outer adjuster 3/4 of a turn. Seat bearings by turning differential carrier three or four turns in both directions. Finish tightening the
adjuster 1/4 turn to its index mark (original location).
10. Reinstall long stub shaft, fill differential with fluid and reinstall transaxle.
11. After installing transaxle check transmission side fluid level.
