Prowler V6-3.5L VIN G (1999)
17
.Remove propshaft from vehicle.
INSTALLATION
1. Verify transaxle is pushed rearward as far as possible.
2. Position front of propshaft to front drive flange pilot. Keep the propshaft on a level plane.
CAUTION: DO NOT TRY TO INSTALL THE PROPSHAFT UNLESS IT HAS CLEARED THE DRIVE FLANGE PILOTS COMPLETELY.
DO NOT ANGLE THE SHAFT UPWARD. DAMAGE TO THE INNER BUSHINGS WILL RESULT.
3. Insert front of propshaft into front bell housing flange pilot.
4. Position rear of propshaft to rear drive flange pilot.
5. Insert rear of shaft over drive flange pilot.
6. Carefully slide transaxle forward to retain shaft.
7. Align drive flanges to couplers at marks made during removal.
8. Install retaining bolts. Tighten bolts to 70 ft. lbs.
9. Install exhaust system and hangers.
10. Install exhaust brackets at the engine bell housing.
11. Lower transmission into position.
12. Install front transmission mount.
13. Install rear transmission mount.
14. Install electrical connectors at transmission.
15. Install gearshift cable to manual valve lever.
16. Connect transmission cooler lines at transmission.
17. Install transmission cooler and bracket.
18. Lower vehicle.
19. Connect battery negative cable.
