Prowler V6-3.5L VIN G (1999)
Fig. 5
8. Deattach ball stud from knuckle. Refer to Steering and Suspension for instructions..
9. Lift up and out on knuckle while grasping axle shaft.
CAUTION: When removing outer C/V joint from hub and bearing assembly, do not allow the flinger disk on hub and bearing assembly to
become damaged. Damage to the flinger disk will cause dirt and water intrusion into bearing. Premature bearing failure will result.
10. Pull out on tire and knuckle and dislodge outer joint from knuckle and hub.
11. Hold outer C/V joint assembly with one hand, and rotate it out until outer C/V joint clears hub and bearing assembly.
Fig. 6
12. Dislodge inner tripod joint from stub shaft retaining snap ring on transaxle assembly. Inner tripod joint is dislodged from stub shaft retaining snap
ring, by inserting a pry bar between transaxle case and inner tripod joint and prying on tripod joint. Only disengage the inner tripod joint from the
retaining snap ring. Do not attempt to remove the inner tripod joint from the transmission stub shaft at this time.