Prowler V6-3.5L VIN G (1999)
Fig. 14
3. Install the spider assembly to interconnecting shaft retaining snap ring into groove on end of interconnecting shaft. Verify the snap ring is fully
seated into groove on interconnecting shaft.
4. Distribute 1/2 the amount of grease provided in the seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into tripod
housing. Put the remaining amount into the sealing boot.
Fig. 15
5. Slide the spider assembly and the interconnecting shaft into the tripod joint housing.
6. Install inner tripod joint seal boot to interconnecting shaft clamp evenly on sealing boot.