Prowler V6-3.5L VIN G (1999)
Power Window Motor: Testing and Inspection
1. Remove door trim panel.
2. Disconnect the power window motor wire harness connector.
3. Connect positive (+) lead from a test battery to either of the two motor terminals.
4. Connect negative (-) lead from test battery to remaining motor terminal.
5. The motor should now rotate in one direction to either move window up or down.
6. Reverse the connections across the motor terminals to check the operation in the other direction. Remember, if the window is in the full up or full
down position, the motor will not operate in that direction by design. If OK, test window switch and/or repair the circuits from the motor to the
switch as necessary. If motor is not OK, replace the window regulator assembly.
7. If the motor operates in both directions, check the operation of the window glass and lift mechanism through its complete up and down travel.
There should be no binding or sticking of the window glass or lift mechanism through the entire travel range. If not OK, refer to the window glass,
tracks, and regulator for sticking, binding or improper adjustment.