Reliant-K L4-156 2.6L VIN G 2-bbl (1983)
FIGURE 3 - DRILLING TEMPLATE PRESSURE REGULATOR BRACKET
7.
To mount the pressure regulator, tape the pressure regulator bracket template, PN 4275240, to the right side shock tower as shown in Figure 3.
Carefully locate the template against the right fender shield and wheel well (keep the top side of the template level). Center punch three screw hole
locations and drill three .165" diameter (#21 drill) holes. Attach the pressure regulator bracket with three selftapping screws, PN 6031991,
tightening securely.
NOTE:
SOME VEHICLES HAVE HEADLAMP-TO-DASH MAIN WIRING HARNESS ROUTING ATTACHED WITH A CLIP AT THE RIGHT
SHOCK TOWER. IF SO, THE HARNESS MAY NEED TO BE REROUTED TO ALLOW ROOM FOR PRESSURE REGULATOR.
REMOVE WIRING FROM EXISTING CLIP AT RIGHT SHOCK TOWER AND DISCARD CLIP. DISCONNECT BOWL VENT HOSE
CLIP LOCATED ON WHEEL WELL BELOW, AND ROUTE HARNESS THROUGH BOWL VENT HOSE CLIP. REATTACH BOWL
VENT HOSE CLIP.
