Recall: Engine Camshaft Plug Retention
FIGURE 2
2.
Ensure that the plug is properly installed, with the edge of the plug recessed at least 1/4" into the cylinder head (Figure 2).
3.
Thoroughly clean the plug area with MoPar Brake and Carburetor Cleaner or equivalent and wipe dry.
4.
Remove the clamp separating the two parts of the epoxy adhesive. Work the epoxy until the material is completely mixed.
5.
As shown in Figure 2, apply epoxy around the outside of the camshaft plug so that it adheres to the exposed 1/4" of cylinder head surface and
