Sundance Duster L4-153 2.5L VIN K FI (1992)
Shift Linkage: Adjustments
Gearshift Mechanism
GEARSHIFT LINKAGE ADJUSTMENT (CABLE OPERATED)
Before replacing the gearshift selector cable or crossover cable for a hard-shifting complaint, disconnect both cables at the transaxle. Then, from
the driver's seat, manually operate the gearshift lever through all gear ranges, If the gearshift lever moves smoothly, the cable(s) should NOT be
replaced. If the gear lever binds replace the cable that is causing the binding condition.
Manual Transaxle Pinned In The Neutral Position To Adjust Gearshift
1. Working over the left front fender, remove the lock pin from the transaxle gearshift (selector shaft) housing.
2. Reverse the lock pin (so long end is down) and insert lock pin into same threaded hole. A hole in the selector shaft will align with the lock pin,
allowing the lock pin to be screwed into the housing. This operation locks the selector shaft in the 3-4 neutral position.
