plymouth Workshop Repair Guides

Plymouth Workshop Service and Repair Manuals

Steering - High Steering Effort/Reduced Returnability|Page 4418 > < Diagram Information and Instructions|Page 4409
Page 1
background image

Firewall: All Technical Service Bulletins
Steering - High Steering Effort/Reduced Returnability

Models

1985 Omni/ Charger & Horizon/ Turismo Equipped With Power Steering

Subject

High Steering Effort/Reduced Returnability

Index

STEERING

Date

May 13, 1985

No.

19-01-85

P-1666-C
SYMPTOM/CONDITION

A concern of higher than expected power steering efforts and/or reduced steering returnability may result if the lower universal joint on the steering shaft
is rubbing on the toe plate and cover. To correct this condition perform the following procedure:

CORRECTION PROCEDURE

Step A

1.

Remove the left front scuff plate and the left side cowl trim panel. Pull the carpet and padding rearward for access to the lower portion of the 
steering column.

2.

Remove the two zip nuts from the toe plate and slide the silencer and seal upward on the column for access to the four (4) screws holding the toe
plate to the floor pan. Remove the four (4) screws.

FIG. 1 - Steering Column - Lower Portion

3.

Push the toe plate up approximately 1/2" and hold in this position (Figure 1). Using a sharp awl, punch four (4) new holes in the floor pan.
Reinstall the four (4) previously removed screws.

NOTE:

THE TOE PLATE GASKET SHOULD BE SUFFICIENT TO COVER THE ORIGINAL SCREW HOLES. IF NOT, SEAL
ORIGINAL HOLES WITH SILICONE SEALER. DO NOT LEAVE ANY EXPOSED OPENINGS IN THE FLOOR PAN.

Steering - High Steering Effort/Reduced Returnability|Page 4418 > < Diagram Information and Instructions|Page 4409