Voyager L4-135 2.2L SOHC (1985)
Turn Signal Switch: Service and Repair
Turn Signal/Hazard Warning Switch
Steering column cover, silencer & reinforcement removal
Turn signal switch replacement
Lock plate removal. Models w/tilt column
1. Remove steering wheel. Refer to ``Steering Wheel, Replace'' procedure.
2. Remove steering column cover, silencer and lower reinforcement.
3. Pry off wiring trough from steering column, then disconnect turn signal/hazard warning switch electrical connector.
4. On models equipped with standard column, proceed as follows:
a. Remove wiper/washer switch-to-turn signal switch pivot attaching screw. Leave turn signal lever in its installed position.
b. Remove 3 bearing retainer and turn signal switch-to-upper bearing housing attaching screws.
5. On models equipped with tilt column, proceed as follows:
a. Remove plastic cover, if equipped, from lock plate.
b. Depress lock plate using tool No. C-4156 and pry retaining ring out of groove with a suitable screwdriver. The full load of the upper bearing
