Voyager L4-153 2.5L SOHC (1990)
2. Install anchor plate over anchor, then install eye of adjuster cable over anchor.
Fig 2 Removing And Installing Shoe Return Springs
3. Engage primary shoe return spring in web of shoe and install free end over anchor.
4. Slide parking brake strut into slot in parking brake lever. Slide anti-rattle spring over free end of strut.
5. Engage parking brake lever with cable. Install parking brake lever into rectangular hole of secondary brake shoe.
Installing Brake Shoes
6. Slide secondary shoe into position and engage with wheel cylinder piston and free end of strut. Install shoe retaining nail, retainer, and spring.
7. Insert protruding hole rim of cable guide into hole in secondary shoe web. Holding guide in position, engage secondary shoe return spring through
both, hole in guide, and hole in web. Using Tool C-3785, install spring over anchor.
-
Be sure cable guide remains flat against shoe web and that secondary spring overlaps primary).
-
Using pliers, squeeze ends of spring loops (around anchor) until parallel.
8. Install adjusting star wheel assembly between primary and secondary shoes, with star wheel next to secondary shoe.
-
The left star wheel adjusting stud end is stamped "L" (indicating its position on the vehicle) and the star wheel is cadmium plated.
-
The right star wheel is black and the adjusting stud end is stamped "R". Install shoe to shoe spring between shoes.
-
Engage primary shoe first.
9. Install adjusting lever spring over pivot pin on shoe web. Install adjusting lever under spring and over pivot pin. Slide lever slightly rearward to
lock in position.
10. Thread adjuster cable over guide and hook end of overload spring in lever.
-
Be sure eye of cable is pulled tight against anchor and in a straight line with guide.
11. Check operation of automatic application adjuster by pulling adjuster cable rearward. Star wheel should rotate upwards.
