Voyager L4-153 2.5L SOHC (1990)
Figure 5
^
Engage the push-in tie strap into the drilled 1/4 inch hole (Figure 5).
NOTE:
THE VALVE ASSEMBLY MUST BE POSITIONED VERTICALLY.
^
Tighten all hose clamps.
^
Install the other supplied tie strap to secure the assembly to the frame rail (Figure 5). Cut off excess strap.
Figure 6
FOR AC AND AY BODIES WITH BENDIX ABS
INSTALLATION OF THE VALVE IS THE SAME AS ABOVE EXCEPT AS FOLLOWS:
THE EXISTING COOLER HOSES ARE RETAINED BY A CLIP AT THE ABS MODULE (FIGURE 6). DRILLING OF A HOLE IS NOT
REQUIRED.
^
Mark the hoses at the rear edge of the clip.
^
Remove the clip.
^
Cut the hoses at the marks.
^
Install the valve assembly and tighten the clamps.