Voyager L4-156 2.6L SOHC (1984)
-
The use of a double straddle cutter which machines both sides of the disc at the same time is highly recommended.
Fig 8 Minimum Disc Thickness Marking
Fig 8 Minimum Disc Thickness Marking
Measurements and specifications when servicing the braking disc:
NOTE: All braking discs (rotors) have markings for minimum allowable thickness cast on an un-machined surface.
-
This marking includes 0.76 mm (0.030 inch) allowable disc wear beyond the recommended 0.76 mm (0.030 inch) of disc refacing.
-
This surface may be as shown, or on an alternate surface.
Do Not Reface Beyond ............................................................................................................................................................... 21.16 mm (0.833 in)
-
Allows for Wear of 0.76mm (0.030 in.)
Minimum Allowable Thickness ................................................................................................................................................ 20.4Omm (0.803 in)
NOTE: For additional information on how to use a micrometer, see Fundamentals and Basics. See: Fundamentals and Basics