Voyager L4-156 2.6L SOHC (1984)
Bleeding Brake System
Caliper Bleeding Screw
CAUTION: Pressure bleed system using equipment designed for this purpose and vehicle only.
1. Wipe master cylinder caps and top with a clean rag.
2. Connect pressure bleeder following manufacturer's instructions for use of bleeder.
3. Attach a clear plastic hose to the bleeder screw at one wheel and insert the other end of the tube into a clear jar containing fresh brake fluid.
4. Open the bleeder screw at least one full turn.
CAUTION: "Cracking" the bleeder screw often allows only a slow weak fluid flow. This may not be sufficient to remove all air from the system.
5. After a good volume of fluid has been forced through the brake system, an "air free flow" in the plastic hose and clear jar indicates a thorough
bleed.
6. Repeat this procedure at all other bleeder screws.
7. Check brake pedal travel. If pedal travel is excessive repeat the procedure.