Voyager L4-2.4L VIN B (1997)
10.
Remove two top bolts from intake manifold rear support bracket.
11.
Remove lower bolt from intake manifold to front support bracket.
12.
Remove dipstick.
13.
Remove dipstick tube.
CAUTION: Moving the dipstick tube will cause damage to the sealer, causing an oil leak. Dipstick tube must be sealed at cylinder block.
14.
Remove upper intake manifold bolts. Remove upper intake manifold.
CAUTION: Cover intake manifold to prevent foreign material from entering engine.
Installation
1.
Install new upper intake manifold gasket.
NOTE: Center outboard fastener is a double stud.
2.
Tighten upper intake manifold fasteners starting at center and progressing outward in both directions. Tighten bolts to 28 Nm (250 inch lbs.).
Repeat this procedures until all fasteners are at specified torque.
3.
Install dipstick tube. Seal tube to cylinder block using Mopar (R) Stud N' Bearing Mount Adhesive. Tighten dipstick tube fastener to 12 Nm (105
inch lbs.).
4.
Install dipstick.
