Voyager L4-2.4L VIN B (1997)
Fuel Rail: Service and Repair
Fig 32 Vacuum Fitting On Rear Of Intake Manifold
REMOVAL
1. Perform fuel system pressure release procedure before servicing or starting repairs. Refer to Fuel System Pressure Release Procedure.
2. Disconnect negative cable from battery.
3. Remove air cleaner inlet hose from throttle body.
4. Remove throttle cable and speed control cable (if equipped) from throttle lever.
5. Remove throttle cables from bracket by compressing retaining tabs.
6. Remove connector from throttle position sensor.
7. Remove connector from idle air control motor.
Fig 33 Electrical And Vacuum Connections
8. Remove vacuum lines from intake plenum fittings (Fig. 32) and (Fig. 33).
9. Remove connector from intake air temperature sensor (Fig. 33).
