Voyager L4-2.4L VIN B (1997)
4. Remove snap ring which retains spider assembly to interconnecting shaft. Remove the spider assembly from interconnecting shaft. If spider
assembly will not come off interconnecting shaft by hand, it can be removed by tapping spider assembly with a brass drift. Do not hit the outer
tripod bearings in an attempt to remove spider assembly from interconnecting shaft.
5. Slide sealing boot off interconnecting shaft.
6. Thoroughly clean and inspect spider assembly, tripod joint housing, and interconnecting shaft for any signs of excessive wear. If any parts show
signs of excessive wear, the driveshaft assembly will require replacement. Component parts of these driveshaft assemblies are not serviceable.