Voyager V6-181 3.0L SOHC (1988)
6.
Align camshaft bearing caps with arrows (depending on cylinder bank) as shown in Fig. 12.
Fig. 13 Identifying bearing caps
7.
Identify number 1 bearing cap as shown in Fig. 13, then install rocker shafts into bearing cap 1 with end notches positioned as shown in Fig. 13,
and machined portion of rocker shaft is facing down.
8.
Install rocker arms, bearing caps and springs onto rocker arm shafts.
9.
Temporarily install number 4 bearing cap bolts to retain assembly.
10.
Apply a suitable sealant at bearing cap ends as shown in Fig. 12.
11.
Install rocker arm shaft assembly. Ensure arrow on bearing cap and arrow mark on cylinder head are pointing in same direction.
12.
Torque bearing caps as follows:
a.
Numbers 3, 2, 1, then 4 to 85 inch lbs.
b.
In same sequence mentioned above, torque bearing cap bolts to 180 inch lbs.
13.
Install distributor housing and tighten bolts to specifications.
14.
Lubricate camshaft oil seals lip with engine oil, then using camshaft oil seal installer tool No. MD998713 or equivalent, install camshaft oil seals.
15.
Using oil seal installer tool No. MB998306 or equivalent, install end seals.
