Voyager V6-181 3.0L SOHC (1988)
E.
Check Door Gap - (Applies Only to Button Application)
-
Form a rectangular box from dum dum (approximately 10 x 10 x 25 MM).
NOTE:
PRECISION IS NOT NECESSARY.
-
Place the dum dum piece on the sheet metal shut face (next to the tension reliever button) with the long end pointed outward.
-
Close the door with enough force to latch it (do not overslam).
-
Open the door and remove the depressed dum dum.
-
Measure the compressed thickness of the dum dum. This is the door gap.
NOTE:
A GAP OF 19 MM OR LESS IS REQUIRED FOR THE TENSION RELIEVER TO SET.
POLICY:
Information Only