Voyager V6-181 3.0L SOHC (1988)
Fuel Tank Pressure Release Valve: Service and Repair
Pressure Relief/Roll Over Valve
REMOVAL
1.
Fuel system pressure must be released prior to service.
2.
Fuel tank must be removed from vehicle prior to service. Refer to FUEL TANK REPLACEMENT AND REPAIR PROCEDURES.
3.
Slide the blade of a screwdriver between the rubber mounting grommet and the fuel tank, making sure not to slide the screwdriver between the
roll-over valve and grommet. Use a second screwdriver to brace the first and pry the roll-over valve out of the tank.
4.
Remove the grommet from the valve, and make sure there is no damage or wear evident on the grommet. If grommet is worn it must be replaced.
Pressure Relief/Rollover Valve
INSTALLATION
1.
Install the rubber grommet into the fuel tank, and seat it around the curled lip of the tank.
2.
Lubricate the grommet with power steering fluid, and push roll-over valve into grommet until properly seated. Twist grommet if necessary to align
to correct position. Reinstall fuel tank.