Voyager V6-201 3.3L (1991)
Parking Brake Pedal: Service and Repair
REMOVE
Equalizer/Bent Nail Adjuster Assembly
- Loosen cable adjusting nut and disconnect front cable from adjuster.
- Remove sill molding/cowl side scuff panel and steering column cover. Increase access by removing fuse box, if required.
- Disconnect brake release cable and electrical connector for light switch. Remove pedal assembly attaching bolts.
- Remove front cable strand button from clevis. Tap cable housing end fitting out of assembly.
INSTALL
- Install cable retainer into pedal assembly bracket.
- Install cable into retainer and strand button into clevis.
- Bolt pedal assembly into place. Install release cable and electrical connector for light switch.
- Install fuse box, steering column cover and sill molding/cowl side scuff panel.
- Connect front cable and adjust parking brake. See: Adjustments