Voyager V6-201 3.3L VIN R SMFI (1997)
Figure 1
1.
Refer to Figure 1 and apply heat to of the areas indicated for one depression at a time. The heat gun should be set for approximately 500° F (260°
C). Keep the gun moving constantly to avoid scorching the paint. Avoid applying heat directly to the roof rack skid strips if so equipped.
2.
Continue applying heat evenly until the depression is removed, the roof panel will usually "pop" when the depression removal is complete.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE: XX - Service Adjustment